Hot Tub Maintenance; 1.1 Cleaning The Filter - Sundance Spas Maxxus Installation & Owner's Manual

other sensors will remain active. To unlock the temperature setting so that
it can be adjusted, simply follow the instructions above under "To Unlock
The Panel."

11.0 Hot Tub Maintenance

Proper and regular maintenance of your hot tub will help it retain its beauty
and performance. Your authorized Sundance Dealer can supply you with all
the information, supplies, and accessory products you will need to accom-
plish this.

1 1.1 Cleaning The Filter

A programmable "Change Filter" reminder flashes on the
CHANGE
control panel display after a specified number days to remind
FILTER
you to clean (or replace) your filter cartridge(s). This reminder
must be reset at each cleaning interval. Refer to section 10.3 (page 30) for
additional information and programming details.
TM
Your Sundance hot tub is equipped with an exclusive MicroClean 2-stage
filter located under the filter lid (Figure-F, Page 16). Fine debris is filtered by
the circulation pump drawing water through the smaller (stage 2) cartridge.
Larger debris is filtered by the main 2-speed pump drawing water through
the larger (stage 1) cartridge during normal operation and at each skim-
ming/heating cycle. Both halves work together to give you unsurpassed
water quality! To ensure optimum performance, clean and reuse the stage
1 cartridge once a month and throw-out (replace) the stage 2 cartridge
every 3 months, or as needed.
All models include filters on their footwell suction covers (Page 16)
that prevent debris from entering pump 2, pump 3, and the diverter
valves, when operating. These filters must remain in place to protect
these components from debris entrapment/damage. They should be
cleaned every 2 months, or when weak pump 2 or pump 3 perfor-
mance is observed.
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE CLEANING
THE FILTER CARTRIDGE! To accomplish this, refer to the
following filter cleaning/replacement procedure:
Page 32