Sundance Spas Maxxus Installation & Owner's Manual page 37

A
B
Loosen filter nut to provide clearance, then
remove filter assembly.
D
Top
Stage 1
(Reuseable)
Rinse debris from the stage 1 filter pleats
using a garden hose and high-pressure nozzle.
Start at the top and work downward to the face.
Repeat process until all filter pleats are clean.
F
Trapped
Air
Bubbles
Submerge assembled filter in spa and tilt each
end upward to remove trapped air bubbles
from inside each filter cavity.
Periodically, the stage 1 filter will need a more thorough cleaning to remove
imbedded oils and minerals. For this, we suggest cleaning as illustrated above
(step D), followed by soaking the filter overnight in a plastic container filled
with a solution of water and a specially formulated filter cleanser available
from your Sundance dealer.
The average life expectancy of the stage 1 filter is approximately two years
with proper care and water quality maintenance. The smaller stage 2 filter
cannot be cleaned and must be replaced (thrown-out) every 3-months, or as
TURN POWER TO HOT TUB OFF!
Filter
Nut
Filter
Face
filter
C
2.
1.
Stage 2
filter
1. Rotate stage 2 retainer counterclockwise
to release, then separate filter assembly.
2. Replace (throw-away) stage 2 filter after 3
months use or as needed. DO NOT reuse!
E
2. 1.
Stage 2
filter
1. Install new stage 2 filter onto clean stage 1 filter.
2. Insert retainer into stage 2 filter and rotate
clockwise to assembly. DO NOT overtighten
retainer (finger tight only).
G
1. Install filter assembly, then tighten filter nut so it
just touches filter face. DO NOT OVERTIGHTEN!
2. Turn power to hot tub back on.
Replace!
DO NOT
Reuse!
Stage 1
filter
(Reuseable)
Stage 1
filter
Filter
Nut
Page 33