System Information; Hot Tub Maintenance; Cleaning/Replacing The Filter Cartridge - Sundance Spas 880 Series Owner's Manual

880 Export Series

12.12 System Information

This menu will display the current information
for the spa. From the Settings Menu, tap
to highlight the "Information" Menu tab. Tap
to enter the selection menu, Figure
Information
12.12a. There are no selections that can be
made. The menu simply provides information.

13.0 Hot Tub Maintenance

Proper and regular maintenance of your hot tub will help it retain its
beauty and performance. Your authorized Sundance Spas dealer can
supply you with all the information, supplies, and accessory products you
will need to accomplish this.
DANGER:
!
BY ENTRAPMENT!
• Keep hair, loose articles of clothing or hanging jewelry away from
suction fittings, rotating jets or other moving components to avoid
entrapment that could lead to drowning or severe injury.
• Never use the spa unless all suction guards, filter, filter lid, or
skimmer assembly are installed to prevent body and/or hair
entrapment.
• Never operate or use the spa if the filter, filter lid, or skimmer
assembly are broken or any part of the skimmer assembly is missing.
Please contact your dealer or nearest service center for service.
• The suction fittings and suction covers in this spa are sized
to match the specific water flow created by the pump(s). If it
is necessary to replace the suction fittings, suction covers or
pump(s), be sure that the flow rates are compatible and are in
compliance with the VGB Safety Act page 2.
• Never replace a suction fitting or suction cover with one rated less
than the flow rate marked on the original suction fitting. Using
improper suction fittings or suction covers can create a body or
hair suction entrapment hazard that may lead to drowning or
severe injury.
• Owners must alert all spa users to the potential risk of Hair,
Limb, Body, Evisceration (disembowelment), and Mechanical
Entrapment, page 6.
13.1

Cleaning/Replacing the Filter Cartridge

A programmable "Change Filter" reminder icon
flashes on the control panel display, after a specified
number of days, to remind you to perform routine
maintenance on your filter system. This reminder
must be reset at each interval. Refer to Section 12.6,
for additional information and programming details.
46
RISK OF SEVERE INJURY OR DROWNING
Information
A
A
or
Water Temp
HiLimit Temp
System State
Flow Sensor
Figure 12.12a
Filter 1 Replacement
Reminder
It's time to clean or replace
your MicroClean Outer filters.
Contact your authorized dealer
if new filters are needed.
Reset Contact your authorized dealer
97 F
99 F
Flow
Closed
Filter 2 Replacement
Reminder
It's time to replace your
MicroClean Inner filter.
Snooze
for a new filter.
Reset Snooze