Familiarization - Culligan Gold Series Owner's Manual

Familiarization

3
Modes of Operation
Manual Regeneration
Pressing and holding the regen button for 3 seconds will initiate an immediate regeneration. The
beeper is to give one beep at the start of manual regeneration (when the motor starts to turn). In delay
mode, pressing and releasing the regen button will light the regen icon for regeneration to occur at the
set delay time. Pressing and releasing the regen button again will turn off the regen icon.
Power Loss
The AccuSoft ® circuit board is equipped with a Hi-Cap Capacitor and EEPROM memory chip. The
capacitor is capable of maintaining the time, for at least one day, in the event of a power outage. The
EEPROM ensures that the individual programming parameters of your softener are not lost.
If the power outage lasts long
enough to drain the Hi-Cap
Capacitor, the control will flash
"12:00 PM" when power is
returned to the control. The
unit will continue to keep time
from the moment power is
restored, and will initiate a
full regeneration at the preset
regeneration time. The time
of day will need to be reset in
order to return the regeneration
to its preset time.
If you live in an area where
power outages occur with a
regular frequency, a battery
backup option is available for
ensuring that the time of day is
properly maintained. Contact
your Culligan Dealer for more
information.
Display Back-lit LCD display.
Program Key Depress to enter and move through the programming steps.
Regeneration Key Press and hold the key for three (3) seconds to initiate an immediate
regeneration.
When pressed during programming the time of day, this key will allow the user
to toggle between the hours and minutes setting of timing program segments.
Information Key Each time depressed, the Information key will display statistical information
such a flow rate, time of day. Use with the Toggle Down key to display other
statistical information.
Toggle Down Key In the programming mode this key will move the user through the programming
function in a descending mode. If depressed for greater than three seconds, the
rate at which the display scrolls through data will increase.
Toggle Up Key In the programming mode this key will move the user through the programming
function in an ascending mode. If depressed for greater than five seconds, the
rate at which the display scrolls through the data will increase.
This key will also allow the user to manually step through the cycles of
regeneration.
Program
Program
Key
Press Regen once to begin regeneration tonight.
Or hold for immediate regeneration.
Toggle
Down
Setting Time Of Day
1. Press Program until 'tod' is displayed.
2. Use arrow keys to adjust minutes.
3. Press Regen once then adjust hours.
4. Continue to press Program to exit menu & save.
Display
Regeneration
Key
Information
Regen Information
Key
Toggle Up