Culligan Gold Series Owner's Manual page 8

Programming
(cont.)
5
4. Backwash Time - This setting is used to program the
backwash. The time of the cycle is kept in minutes. The
display will show the "BACKWASH" and "MINS" icons
and the cycle time in the right most digits. Adjust the
value with the "+" or "-" keys.
Pressing the "Status" key will save the setting and move
to the next programming step.
5. Pause Cycle - This setting is used to set the time in
minutes for brine drain/slow rinse cycle. The display
will show the "BRINE RINSE" and "MINS" icons and the
cycle time in the right most digits. Adjust the value with
the "+" or "-" keys.
Pressing the "Status" key will save the setting and move
to the next programming step.
6. Fast Rinse - This setting is used to set the time in
minutes for the fast rinse cycle. The display will show the
"FAST RINSE", "/", "REFILL" and "MINS" incons and the
cycle time in the right most digits. Adjust the valve with
the "+" or "-" keys. Pressing the "Status" key will save
the setting and move to the next programming step.
7. Day(s) of Week
Regeneration - The
following optional days of the
week setting will be available
to trigger regeneration. The
display will show "dAYoWK"
for 2 seconds followed by
"NO". The "+" or "-" key will toggle "yes" or "no" (default
is NO). A "yes" response will indicate that the control is to
perform a regeneration on specific days of the week.
Pressing "STATUS" will save and advance to the next
step. If "NO" was chosen, then the control will only initiate
regenerations based upon the interval (in number of days) and the display will show as shown in
Regeneration Interval on the right.
If "YES" was chosen, then the specific days of the week to regenerate will be selected as follows:
The display will show "dAY"
for two seconds followed by
"SUN N". The "regen" key
toggles the days of the week
and the "+" and "-" keys
toggle "Y or N".
Pressing the "STATUS" key saves and advances to the next step.
If any of the days were set to
"yes", the display will show
"SETDAY" followed by "SUN".
This selects the current day
of the week. The "+" or "-"
key toggles through the days
of the week and pressing the
"STATUS" key saves the setting and advances to the next programming step.
10
BACKWASH
2
BRINE RINSE
10
FAST RINSE / REFILL
NO
SUN
SUN
MINS
MINS
MINS