Table of Contents
Advertisement
3 6
Adjusting the Blower Speed
The internal blower helps transfer
the heat from the fireplace into the
room. It will not turn on until the
fireplace is up to temperature
(approximately 10 minutes after
starting). See the illustration below
for instructions on adjusting the
blower speed.
Optional Power Heat Duct
Allow the fireplace to reach normal operating temperature. Then use the wall-mounted rheostat to
operate the blower speed. The blower will automatically shut off after the fireplace cools.
Normal Operating Sounds
The appliance will creak with
change of temperature.
Pilot Flame
The pilot flame, which remains on,
makes a very slight "whisper"
sound.
Gas Control Valve
As the gas control valve is turned on
and off you will hear a dull clicking
sound. This is the valve opening up
and shutting down.
Normal Operating Odors
This appliance has several areas that reach high temperatures. Dust or other particles on these areas
may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if
the appliance was left idle for a long period.
Travis Industries
Operation
OFF
Turn the dial all
the way counter-
clockwise until it
clicks off.
Blower Knob
OFF
HI
Turn the knob all the way counter-clockwise to turn
LO
the blower off. One click clockwise turns the
blower to high speed. Turning the knob clockwise
from the high position decreases the speed of the
BLOWER
blower.
CONTROL
HIGH
The high position is
all the way counter-
clockwise, without
clicking off.
Blower Snap Disk
This part can produce a clicking sound as it turns
the blower on and off.
Extinction Pops
It is not unusual, especially on Propane (LP) appliances,
to experience a "pop" when the burner is shut off.
4030228
LOW
Turn the dial
all the way
clockwise.
Blower
This heater uses a blower to push heated air into
the room. You will hear the sound of air movement
that increases as the speed is increased.
9 3 5 0 8 1 2 8
Hide quick links:
Advertisement
Table of Contents
