Operation; Before You Begin; Location Of Controls - FireplaceXtrordinair 36 DV XL Owner's Manual

Before You Begin

! Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.
Location of Controls - See explanation below
The pilot flame is located
below the rear log.
An instruction card for
operating the fireplace
is attached to the
inside of the fireplace
here. Replace it for
easy reference.
Gas Control Valve
Gas Control Knob Flame Adjust Knob
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer
Travis Industries

Operation

Open the access door
to view the controls.
PILOT
IGNITER
ON
OFF
On/Off Switch Pilot Igniter
This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of the
knob indicates the position this knob is in.
above the knob points to the position this knob is in.
4030228
OFF
HI
LO
BLOWER
CONTROL
Blower Knob
3 3
9 3 5 0 8 1 2 8