Controls - Grizzly H8115 Owner's Manual

2.
Screw the cup onto the top of the
body.
3.
Install the barbed hose fitting into the
base of the gun handle and tighten in
place with the lock nut.
4. Secure the air hose to the barbed fit-
ting with a hose clamp, or use a
NPT quick connect fitting (not includ-
ed).
Note: A
⁄ " NPT quick connect set-up
1
4
will make operation and maintenance
tasks easier.
5. Attach the spray gun to an air supply
regulated between 45 and 60 PSI.
Note: For the best results, use a hose
dedicated for spray use only. Do not
use a hose that has been used with
an in-line oiler or other possible con-
taminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
-10-
Atomizing Cap
⁄ "
1
4
Trigger
Air Flow Control
Figure 4. H8115 Controls.
Atomizing Cap
Trigger
Air Flow Control
Figure 5. H8117 Controls.
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
6. Cup: Holds material; includes a vent-
ed cap.
Model H8115/H8117 Spray Gun

Controls

Cup
Pattern Control
Fluid Control
Cup
Fluid Control
Pattern Control