Assembly; Controls - Grizzly H8116 Owner's Manual

Assembly

1.
Screw the cup onto the body.
2.
Install the barbed hose fitting into the
base of the gun handle and tighten in
place with the lock nut.
3.
Secure the air hose to the barbed fit-
ting with a hose clamp, or use a
NPT quick connect fitting (not includ-
ed).
Note: A
⁄ " NPT quick connect set-up
1
4
will make operation and maintenance
tasks easier.
4.
Attach the spray gun to an air supply
regulated between 45 and 60 PSI.
Note: For the best results, use a hose
dedicated for spray use only. Do not
use a hose that has been used with
an in-line oiler or other possible con-
taminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
Model H8116 Spray Gun
Trigger
⁄ "
1
4
Figure 2. H8116 Controls.
1. Pattern Control: Adjusts the spray
pattern width.
2. Air Flow Control: Controls the fluid
pressure inside the spray gun and
the volume of material that travels
through the fluid tip.
3. Trigger: Two stage trigger. Stage one
releases compressed air for blowing
off the work piece and purging the
tip after spraying; stage two sprays
material.
4. Cup: Holds material; Includes a vent-
ed cap.

Controls

Cup
Pattern Control
Air Flow Control
-9
-