Step 5: Fuel Tank Connections; Step 6: Brake Set-Up - Stanley 36FS Owner's Manual

Step 5: Fuel tank connections

Locate the fuel tank on the fuel tank bracket with the
recessed area pointing toward the rear so any spills drain
away from the engine. Align the fuel valve in the center of the
clearance hole. Place the fuel tank straps into position,
wrapping them around the tank and the bracket.
Once the fuel tank and straps are in place, securely tighten
the straps using the bolts provided. Next, firmly attach the
fuel line to the fuel valve nipple. Tighten all connections to
ensure they are firm and secure so the fuel system is tightly
attached.
DANGER
DANGER GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. FUEL LEAKS, A LOOSE FUEL TANK, OR A LOOSE
FUEL VALVE CAN LEAD TO SEVERE INJURY OR DEATH.
ENSURE ALL CONNECTIONS ARE SECURE AND INSPECT
THOROUGHLY FOR ANY POTENTIAL LEAKS IN THE FUEL
SYSTEM. IF YOU FIND A LOOSE CONNECTION OR A LEAK,
MAKE AN IMMEDIATE REPAIR OR ASK FOR ASSITANCE
FROM A PROFESSIONAL MECHANIC OR SERVICE CENTER.
DO NOT OPERATE THIS MOWER IF ANY COMPONENT
OF THE FUEL SYSTEM IS LOOSE OR LEAKS GASOLINE!

Step 6: Brake Set-up

1. Set the brake bar 3/4-1 inch from the tire.
2. With the brake pivot
leaning slightly
forward, install the
washer and pin.
Rev: Mar2011
Assembly Instructions
Note: Verify tire
pressure. Do not exceed
the recommended
maximum.
STANLEY
3. Slide the brake handle to the bottom of the slot then
connect the brake pivot to the brake handle.
4. Slide the brake handle to
the Set position to clamp
the brake bar against the
tire.
Note: If more or less brake
force is necessary or desired,
repeat the procedure, changing the gap in Step 1.
®
Finish Mower
9
Battery pan
36FS, 54FS