Step 3: Wire Harness Assembly And Connections; Step 4: Throttle And Choke Cable Connections - Stanley 36FS Owner's Manual

Step 3: Wire Harness Assembly and Connections

The pre-wired handle bar assembly has a total of four
(4) connections. Route the wire harness as shown in
the top right photo and make the following
connections indentified by number in the other
photos:
1. Route the smaller, white, 2-pin connector through
a hole in the chassis and connect it to the blade
activation safety switch 2-pin connector.
2. Connect the larger, 5-pin connector to the mating
connector at the rear of the engine.
3. Connect the black wire to a ground lug located on
the back or side of the engine.
4. If equipped, attach the yellow wire to the bottom
of the starter motor solenoid on the engine, with
the positive (red) battery cable.
Attach the positive (red) and ground (black) battery
terminal wires to the battery to provide power to the
electric starter.
Note: Battery ground should be to the engine block.
Once all connections are made, use the provided
black wire-ties to strap the wire harness into place
permanently to the handle bars and chassis.

Step 4: Throttle and Choke Cable Connections

The throttle and choke are shown in the adjacent
photo. See instructions for connecting them to the
engine in the Engine Owner's Manual provided.
Rev: Mar2011
Assembly Instructions
®
STANLEY Finish Mower
8
36FS, 54FS
Choke
Throttle