Step 5: Fuel Tank Connections; Step 6: Brake Set-Up - Stanley 54FS Owner's Manual

Assembly Instructions 36FS, 54FS
Step 5: Fuel tank connections
Locate the fuel tank on the fuel tank bracket with the
recessed area pointing toward the rear so any spills
away from the engine. Align the fuel valve in the center of the
clearance hole. Place the fuel tank straps into position,
wrapping them around the tank and the bracket.
Once the fuel tank and straps are in place, securely tighten
the straps using the bolts provided. Next, firmly attach
fuel line to the fuel valve nipple. Tighten all connections
ensure they are firm and secure so the fuel system is ti
attached.
DANGER I
DANGER GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. FUEL LEAKS, A LOOSE FUELTANK, OR A LOOSE
FUEL VALVE CAN LEAD TO SEVERE INJURY OR DEATH.
ENSURE ALL CONNECTIONS ARE SECUREAND INSPECT
THOROUGHLY FOR ANY POTENTIAL LEAKS IN THE FUEL
SYSTEM. IF YOU FIND A LOOSE CONNECTION 0RA LEAK,
MAKE AN IMMEDIATE REPAIR ORASK FOR ASSITANCE
FROM A PROFESSIONAL MECHANIC OR SERVICE CENTER.
Step 6: Brake Set-up
1. Set the brake bar 3/4-1 inch from the tire.
Note: Verify tire
pressure. Do not exceed
the recommended
maximum.
.
Slide the brake handle to the bottom of the slot then
connectthe brake pivotto the brake handle.
.
With the brake pivot
leaning slightly
forward, install
washer and pin.
.
Slide the brake handle to
the Set position to clamp
the brake bar againstthe
tire.
Note: If more or less brake
force is necessary or desired,
repeat the procedure, changing the gap in Step 1.
Rev: Mar2011
STANLEY® Finish Mower
9