Set Up Instructions - Stamina InMotion E-1000 Owner's Manual

SET UP INSTRUCTIONS

Place the InMotion E1000 in the area where it will be used. It is recommended that the InMotion E1000
be placed on an equipment mat. The InMotion
tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 4.5 feet long is required for safe
operation of the InMotion
around the InMotion
LEVELING: Adjust the location of InMotion
the floor without rocking.
MOVING: Grasp the REAR STABILIZER(2) to move the InMotion
to move the InMotion E1000. The Pedal Arms will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the InMotion
the function of the InMotion
follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that
the drive train functions properly. Adjust the TENSION KNOB(21) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(55) on the InMotion E1000. Make sure that all users
read the WARNING LABEL(55).
E1000. Make sure that adequate space is available for access to and passage
E1000.
E1000 to verify that assembly is as shown in the above illustration. Check
E1000. Stand on the foot pedals. Slowly move your highest foot forward and
E1000 is approximately 24 1/4" long x 17" wide x 11 3/8"
E1000 on the floor to make the InMotion
7
E1000 sets on
E1000. Do not use the Pedal Arms
Equipment Mat