Hardware Identification Chart - Stamina InMotion E-1000 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
All hardware are already attached to the parts. After unpacking the unit, make sure that you have all the
following items on the parts.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
42
45
46
51
40
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M10 x 1.5 x 43mm)
Bolt, Button Head (M8 x 1.25 x 20mm)
Bolt, Button Head (M8 x 1.25 x 42mm)
Nylock Nut (M10 x 1.5)
Stand
5
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
2
4
2
2
2