Omron E5EN User Manual page 77

CHAPTER 5 PARAMETERS
Operation Level
Upper limit alarm value 1
Lower limit alarm value 1
This parameter independently sets the upper and lower limit alarm values when the mode for
setting the upper and lower limits is selected for alarm 1 type (initial setting level).
This parameter sets the upper and lower limit values of alarm 1.
During temperature input, the decimal point position is dependent on the currently
selected sensor, and during analog input it is dependent on the decimal point"
Function
parameter setting.
Comment
F
Related parameters
Alarm 1 type" (initial setting level) (p. 5 25)
Standby sequence reset method" (p. 5 31) Alarm 1 open in alarm" (p. 5 32) Alarm
See
1 hysteresis" (p. 5 32), alarm 1 latch (advanced function setting level)
Upper limit alarm value 2
Lower limit alarm value 2
This parameter independently sets the upper and lower limit alarm values when the mode for
setting the upper and lower limits is selected for alarm 2 type (initial setting level).
This parameter sets the upper and lower limit values of alarm 2.
The decimal point position is dependent on the currently selected sensor.
Function
Comment
F
Related parameters
Alarm 2 type" (initial setting level) (p. 5 25)
Standby sequence reset method" (p. 5 31) Alarm 2 open in alarm" Alarm 2 hyster
See
esis" (p. 5 33), alarm 2 latch (advanced function setting level)
5-8
Setting Range Unit
1999 to 9999
Setting Range Unit
1999 to 9999
Alarm 1 type must be set to upper and lower
limits, upper and lower limit range or upper
and lower limit alarm with standby sequence.
Default
EU 0
Alarm 2 type must be set to upper and lower
limits, upper and lower limit range or upper
and lower limit alarm with standby sequence.
Default
EU 0