Alinco DJ-V17TFH Instruction Manual page 16

2.Accessories
2
Charging the Battery Pack Using DC-Jack on the Unit
The unit can charge the EBP-65 and EBP-66 optional Ni-MH battery packs by
supplying DC power through the DC-jack on the unit using EDC-146/147/148 wall
chargers or an optional DC power supply (DC 12V~DC 16V, 1A or more: IEC/EN
60950 compliant).
1. Attach the battery pack by referring to "Battery Pack" (page 15).
2. Connect the AC adapter plug to the DC-jack on the
unit then connect the charger's adapter to the wall
outlet.
* AC adapter may look different.
3. Turn on the unit and set the battery charge
parameters. Please refer to "Set Mode" (page 44)
then:
* "Battery Charge Function" (page 48)
Select CHG-ON.
* "Battery Type Setting" (page 49)
Select BATT-NI.
4. After completing the settings, a flashing
appears on the display. Make sure the icon is
flashing then turn off the unit. It takes about 10
hours/30hours for EBP-65/66 respectively to
complete the charge.
IMPORTANT NOTE:
While this function is activated, without attaching a battery pack or the remaining
battery level is below the usable range, the unit turns on by just connecting the
DC source such as an adapter or a DC cable (without operating the power key).
16
Caution
• Li-ion battery packs can't be charged using DC-jack on the unit (Only Ni-
MH battery packs can be charged).
• Risk of explosion, generation of heat or leak of chemicals inside if the
battery is replaced by an incorrect type. Use always the recommended
types of batteries in this manual only.
AC adapter*
AC adapter plug