Table of Contents
Advertisement
3.
Specify the following settings:
•
Device Name. This value is the name of the router.
•
LAN TCP/IP Setup.
-
IP Address. The LAN IP address of the router.
-
IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP
address, the IP subnet mask allows a device to know which other addresses are
local to it, and which must be reached through a gateway or router.
-
RIP Direction. RIP (Routing Information Protocol, RFC1058 and RFC1389)
allows a router to exchange routing information with other routers. The RIP
Direction selection controls how the router sends and receives RIP packets. Both
is the default.
•
When set to Both or Out Only, the router broadcasts its routing table
periodically.
•
When set to Both or In Only, it incorporates the RIP information that it
receives.
-
RIP Version. This setting controls the format and the broadcasting method of the
RIP packets that the router sends. (It recognizes both formats when receiving.) By
default, Disabled is selected.
•
RIP-1 is universally supported. RIP-1 is probably adequate for most networks,
unless you have an unusual network setup.
•
RIP-2 carries more information. Both RIP-2B and RIP-2M send the routing
data in RIP-2 format.
-
RIP-2B uses subnet broadcasting.
-
RIP-2M uses multicasting.
•
DHCP Server. For more information, see
-
Use Router as a DHCP Server. This check box is selected so that the router
functions as a Dynamic Host Configuration Protocol (DHCP) server. See
Settings
on page 76.
-
Starting IP Address. Specify the start of the range for the pool of IP addresses in
the same subnet as the router.
-
Ending IP Address. Specify the end of the range for the pool of IP addresses in
the same subnet as the router.
•
Disable NAT/NAPT. Disable network address and port translation.
•
Address Reservation. For more information, see
page 76.
When you specify a reserved IP address for a computer on the LAN, that computer
receives the same IP address each time it accesses the router's DHCP server. Assign
reserved IP addresses to servers that require permanent IP settings.
4.
Click Apply to save the changes.
Verizon 4G LTE Router MBR1515LVW
DHCP Settings
Advanced
75
on page 76.
Reserved IP Addresses
DHCP
on
Advertisement
Table of Contents
