Setting Up The System; Network Connection; Local Connection - Konica Minolta bizhub C353 User Manual

Overview
1.3

Setting up the system

In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the fax driver onto the computer
being used.
!
Detail
This manual describes the setup method of network connection only for Port9100/IPP/IPPS that will be
installed by the installer, and LPR/Port9100 that will be installed by Add Printer Wizard printing.
For installation procedures via other network connections, refer to the User's Guide (Print Operations).
1.3.1

Network connection

1
Connect this machine to a computer.
2
Make sure the computer is connected to the network.
3
Specify the IP address of the machine to connect it to the network.
4
Depending on the connection method and protocol, change the network settings of this machine.
– LPR: Enable LPD print on the LPD Setting screen.
– Port9100: Enable the RAW port number (9100 at default), on the TCP/IP setting screen.
– SMB: Specify "Print Setting" on the SMB Setting screen.
– IPP/IPPS: Enable IPP print on the IPP Setting screen.
5
Install the fax driver.
– Specify the network port of the fax driver according to the connection method and protocol.
1.3.2

Local connection

1
Connect this machine to a computer
2
Install the fax driver.
!
Detail
For details on connecting this machine to a computer, refer to the User's Guide [Print Operations].
To update an existing fax driver, delete the existing fax driver first. For details, refer to
fax driver" on page
Fax Driver
2-17.
1
"Uninstalling the
1-5