Entering A Plug 'N Power House Code; Controlling Lights And Appliances Using An Ir Command Console - Radio Shack 6-in-1 Remote Control Owner's Manual

15-1923.fm Page 13 Monday, July 19, 1999 12:41 PM
Entering a Plug ' n Power House Code
Your Plug 'n Power Wireless Remote Control
System uses a master code called a house code
(see your IR Command Console's or Plug 'n Pow-
er Wireless Remote Control System's Owner's
Manual for more information).
1. Press Plug 'n Power on the 6-in-1 Remote
Control.
2. Hold down
SET UP
light above turns on.
3. Use the 6-in-1's number keys to enter the
numbers equivalent to the house code's let-
ters ( for A, for B,
1 2
For example, if the house code is C, press
4. Press on the 6-in-1.
ENT
When the red light turns off, the 6-in-1 has
accepted the code.
Note: If the code you entered is invalid, the
red light flashes for about 3 seconds then
turns off. Start again from Step 1.
Controlling Lights and Appliances Using
an IR Command Console
Follow these steps to control Plug 'n Power mod-
ules with your 6-in-1 using an IR command con-
sole.
1. Position the IR command console within the
6-in-1's line of sight.
2. Plug the IR command console's power cord
into any standard AC outlet.
3. Set the house code dial on top of the IR com-
mand console to the same letter as your
Plug 'n Power modules.
4. Set the selector switch on the IR command
console for the group of modules you want to
control (1–4 or 5–8).
Need help? Call 1-800-989-4706
on the 6-in-1 until the red
for C, and so on).
3
.
3
13