If You Have Problems; Manual Code Search - Radio Shack 15-1990 Owner's Manual

15-1990.fm Page 27 Tuesday, December 14, 1999 12:45 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 3-in-One Pocket Remote Control does not op-
erate your remote-controlled devices when you first
set it up, you might have to manually find the correct
code for your devices. You can try all the codes listed
in "Manufacturers' Codes" on Page 11 for the brand
of your device, or you can follow these steps to
search the remote control's entire library.
1. Manually turn on the device you want to set up.
2. Press the corresponding device key (
).
CBL
3. Hold down until the red light blinks twice, then
P
press ,
MUTE MUTE
blinks twice again.
4. Aim the remote control at the device you want to
operate.
5. Repeatedly press
until the device turns off.
6. When the device turns off, press
seconds to save the code.
Note: If you do not press
the remote control does not save the code.
• Because the remote control's library has so
many codes, this procedure can take several
minutes.
• If your device turns off during the search, but
does not operate after you lock in the code,
begin the search again, pausing longer
between key presses.
If necessary, repeat these steps for each device.
,
TV VCR
, then . The red light
VOL –
then the device key
POWER
within 10
P
within 10 seconds,
P
, or
27