Finishing; Mantel Projections - Heat & Glo SL-950TR-E Owner's Manual

11 11

Finishing

A. Mantel Projections
Figure 11.1 shows the minimum vertical and corresponding
maximum horizontal dimensions of appliance mantels or
other combustible projections above the top front edge of
the appliance.
All measurements are in inches.
6
5
4
3
4
TOP OF HOOD OR FIREPLACE OPENING
Figure 11.1 Clearances to Mantels or other Combustibles
above Appliance
3-1/2 in.
1/2 in.
NON-COMBUSTIBLE ZONE
Figure 11.2 Non-Combustible Zone
Models: SL-550TR-E, SL-750TR-E
SL-550TR-IPI-E, SL-750TR-IPI-E
48
CEILING
12
11
10
9
8
7 32
13
12
11
10
9
8
7
6
5
1/2 in. SHEETROCK
OR COMBUSTIBLE
MATERIAL
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. K • 9/08
2-7/8 IN.
MINIMUM
Note: Clearance from opening
to perpendicular wall.
Figure 11.3 Mantel Leg (Acceptable on both sides of opening.)
5-3/8 IN.
MINIMUM
Note: Clearance from opening
to perpendicular wall.
Figure 11.4 Wall Projection (Acceptable on one side of opening.)
3-1/2 in.
1/2 in.
NON-COMBUSTIBLE ZONE
Figure 11.5 Non-Combustible Zone
Models: SL-950TR-E, SL-950TR-IPI-E
1/2 IN.
MINIMUM
3 FT. MAXIMUM
3 IN.
MINIMUM
UNLIMITED
1/2 in.
SHEETROCK
NON-COMBUSTIBLE
BOARD SHIPPED
WITH APPLIANCE