Table of Contents
Advertisement
Rewire To 440V
(G4815 Only)
To rewire the Model G4815 to 440V:
1.
Disconnect the sander from the power
source!
2.
Replace the power indicator light in the
pedestal switch to one suitable for 440V
operation
3.
Remove the RHN-18 overload relay and
replace it with a RHN-10 (8.5-12.5A) type,
set to 10A (Figure 7).
RHN-10
Overload Relay
Figure 7. Overload relay.
4.
Remove the CN-18 magnetic contact over-
load relay and replace it with a CN-16 type
(Figure 8).
Ultimate Series Jointers
CN-16
Magnetic
Contactor
Overload
Relay
Figure 8. Overload relay.
5.
Wire the motor as shown on the diagram on
the inside of the motor wire cover. Note—
The circled references on the diagrams rep-
resent labels on the wires. Also, Figure 9
below has been provided for your reference
and are current at the time that this manual is
being written. However, always use the dia-
gram on the wire cover that comes with your
motor!
G4815
Motor Wiring
4
5
6
7
8
9
1
2
3
R S T
220V
Figure 9. 440V motor wiring.
4
5
6
7
8
9
1
2
3
R S T
440V
-11-
Advertisement
Table of Contents
