Rewiring To 440V - Grizzly G5912Z Owner's Manual

Rewiring to 440V

The Model G7214Z can be rewired for 440V
operation. This rewiring job consists of discon-
necting the saw from the power source, replac-
ing the existing electrical components with those
included in the 440V conversion kit, then rewiring
the motor.
The Model G7214Z 440V Conversion Kit can
be purchased by calling our customer service
number at (800) 523-4777 and ordering item#
P7214Z156A.
We strongly recommend having a qualified elec-
trician perform this task. At the very least, the
resulting conversion job MUST be approved by a
qualified electrician before the saw is connected
to the power source.
To rewire the Model G7214Z for 440V opera-
tion:
1. DISCONNECT SHAPER FROM POWER!
2. Remove the control panel cover and carefully
rotate it to expose the electrical components
attached to the backside.
3.
Replace the existing magnetic switch assem-
bly (Figure 2) with the magnetic switch
assembly from the 440V conversion kit.
Figure 2. Magnetic switch assembly
G5912Z/G7214Z Heavy-Duty Shaper
4.
Replace the control panel cover.
5. Remove the cabinet cover to gain access to
the motor inside the cabinet.
6.
Remove the junction box cover from the
motor, and review the diagram on the inside
of that cover.
7. Wire the motor as indicated on the diagram
for 440V (or high voltage).
8.
Replace the junction box cover and cabinet
covers.
-9-