Model G9953Zxf 440V Conversion - Grizzly EXTREME G9860 Owner's Manual

Grounding Requirements
NOTICE
No adapter is available or should be used
with this machine. If the machine must be
reconnected for use on a different type of
electric circuit, the reconnection should be
made by qualified service personnel; and
after reconnection, the machine must com-
ply with all local codes and ordinances.
Extension cords (G9860, G9860ZX,
G9953, & G9953ZX Only)
Minimum Gauge Size ...........................12 aWG
Maximum Length (Shorter is better).......50 ft.
Extreme series Jointer (Mfg. since 9/11)
Model G9953ZXF
440v conversion
to operate your jointer with 440V power, you
must: 1) replace the magnetic switch contactor, 2)
replace the overload relay, 3) replace the power
lamp and oN button light bulbs, 4) re-wire the
motor, and 5) have an electrician hardwire the
machine to a locking disconnect switch.
refer to page 52 for the full 440v Wiring
Diagram.
you MuST disconnect the
machine from the power
source before beginning
any of the following 440v
conversion
to avoid serious personal
injury or death by electro-
cution.
Replacing contactor & Overload
Relay
1. disCoNNECt JoiNtEr FroM poWEr!
2. remove the control panel from the electrical
pedestal to access the contactor and over-
load relay.
3.
replace the existing contactor and overload
relay with those from the 440V Conversion
Kit (part Number p9953zXF042) (refer to
pages 51– 52 for detailed illustrations), then
set the overload relay load dial to 7, as shown
in Figure 6 on the next page.
procedures
-11-