Maintaining The Batteries - Robertshaw RS4110 Installation Manual

Single stage thermostat

Hide thumbs Also See for RS4110:

User manual (33 pages)

Installation manual (33 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

Installing the Robertshaw Thermostat Base

NOTE: For new installations, mount the thermostat on an inside wall, five feet

above the floor. Do not install behind a door, in a corner, near air vents,

in direct sunlight, or near any heat or steam generating fixtures.

Installation at these locations will affect thermostat operation.

1. Be certain power is off to the heating and cooling systems.

2. Remove the backplate by placing your finger through the wire opening.

Pull the backplate straight out from the body.

3. Place the backplate in position on the wall. Pull the wires through the

wire opening.

4. Hold the backplate level and mark the mounting holes on the wall.

5. Drill the marked holes using a 5 mm (3/16 in.) drill bit.

6. Tap in the wall anchors and secure the base to the wall with the

supplied screws.

NOTE: The thermostats are designed to also mount on a single gang

junction box.

Wire Opening

Providing Power to the Thermostat

To take advantage of the Pop-Up Wizard, power should be applied when the

settings are ready to be entered. Fill in the chart in the Pop-Up Wizard

section before applying power.

These thermostats will run on either two AA batteries or 24 VAC. If the

common wire from the transformer is not available, the unit must be powered

by two AA batteries.

Thermostats with batteries and powered by 24 VAC will continue to function if

the 24 VAC fails.