Replacing The Batteries - Robertshaw 9700 User Manual

28
Changing dip switch settings:
1. Use a small screwdriver or pencil to move the switch to the
desired setting.
2. Press RESET button. See Figure 5. Pressing RESET will erase
any previously entered programming information.
IMPORTANT: New dip switch settings for Dip Switch #2 will not
register or operate options until the RESET button is pressed.

REPLACING THE BATTERIES

This thermostat has two levels of low battery indication. As the
batteries weaken, the thermostat will go to the next stage of low
battery indication.
Low Battery—Stage 1
"LO BATT" stays constant on the display. Replace batteries soon.
Display and thermostat functions normal.
Low Battery—Stage 2
"LO BATT" stays constant on the display and thermostat "beeps"
about once a minute. Replace batteries immediately. Display and
thermostat functions normal.
NOTE: When changing the settings on "SWITCH 1", the reset
button does not have to be pressed for the new configuration to
register or operate.
OPERATION
TCH 1
-
-
Figure 5
MON
F
PM
M A N U A L
+ - +
+ - +
RESET
LO
BATT HEAT