Connecting The Wires - Robertshaw RS4110 Installation Manual

System Switch Selection
The body of the thermostat has two switches on the backside. They are
accessible by removing the backplate from the body. The installer should set
these to match the system.
If the thermostat is controlling a heat pump system, set the first switch to
Heat Pump. The second switch can be left as is.
If the thermostat is controlling a non-heat pump system, set the first switch to
Non-Heat Pump. The second switch must be set to match the system as Gas
or Electric.
If Non-Heat Pump and Gas are selected, the heating system will control the fan.
If Non-Heat Pump and Electric are selected, the thermostat will control the fan.
Heat Pump or Non-Heat Pump

Connecting the Wires

1. The wire ends should be stripped back 8 mm (5/16 in.).
2. Use the Wiring Diagrams and secure the wires into the terminal strip.
If replacing another thermostat, the wires should have been labeled.
Match the labels to the terminals. Tighten the screws.
3. Pull lightly on each wire to ensure the connection is secure.
NOTE: Nightlight feature is only enabled when the RH/R and C terminals
are connected.
Non-Heat
Heat
Pump
Pump
4
Gas or Electric
Gas
Electric