Adjustments; Cutting Depth - Grizzly H2801 Instruction Manual

SECTION 5: ADJUSTMENTS
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.

Cutting Depth

Cutting depth is controlled by moving the infeed
table up/down in relation to the cutterhead and
outfeed table. The infeed table can be controlled
by turning the adjustment knob beneath the
infeed table. To adjust the cutting depth:
1. Place a straightedge evenly on the surface
of the outfeed table so the straightedge
extends over the cutterhead and across the
infeed table as shown in Figure 6.
2. Measure the distance from the infeed table
to the bottom of the straightedge as shown in
Figure 7. This measurement will be the
depth of cut.
3. Adjust the infeed table to the desired depth
of cut. The maximum depth of cut for this
machine is 5 ⁄ ". However, we recommend
64
1
cutting at ⁄ " depths for increased safety.
16
-12-
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.
Figure 6. Straightedge across outfeed table.
Figure 7. Measuring cutting depth.
Do not exceed a cutting depth of
to follow this caution will seriously increase
the risk of kickback and possible injury!
5
⁄ ". Failure
64
H2801 4" Jointer