for your own safety read instruction manual before operating this equipment the purpose of safety symbols is to attract your attention to possible hazard- ous conditions. this manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. the progression of symbols is described below.
Page 3
safety instructions for pneumatic tools 10. use proper air hose for the tool. Make sure your air hose is in good condition and is long enough to reach your work without stretching. 11. Wear proper apparel. do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry which may get caught in moving parts.
Page 4
basic stapler safety in addition to the rules stated in the previ- ous section, and those in the warning boxes throughout this manual, please observe the following safety tips for your new stapler: read this entire before operating stapler. alWays disconnect air from the stapler Whenever ser- vicing or installing staples.
When replacing staples in your model h5977, follow these guidelines: gauge: 15 staple sizes: 1"–2"...
Page 8
operating stapler if you have not read the safety instruc- tions in this manual, do not operate the stapler. Before you operate your stapler, place one drop of pneumatic tool oil into the quick connect fitting where the stapler connects to the air supply.
clearing Jammed staples this stapler may accidentally fire if you work on it without disconnecting it from the air supply. always discon- nect air from stapler whenever clear- ing a jammed staple! to clear a jammed staple from the dis- charge area on the model h5977: disconnect the stapler from the air supply!
Page 11
h5977 part breaKdoWn 109-1 Model h5977 (Mfg. since 2/07)
Page 12
REF PART # DESCRIPTION PH5977101 CYLINDER PH5977103 BUMPER PORP050 O-RING 49.7 X 3.5 P50 PH5977105 DRIVER PRP07M ROLL PIN 6 X 20 PSS31M SET SCREW M5-.8 X 8 PH5977108 PISTON POLE PH5977109 PISTON CAP PORP012-5 O-RING 12.3 X 2.4 P12.5 PH5977111 O-RING 32 X 4.5 PH5977112 SEALING SLEEVE PH5977113 O-RING 12.8 X 1.8...
troubleshooting problem air leaking from stapler body assembly joint. air leaking between hous- ing and hose. tool skips staples while discharging. tool fires slowly or has a loss of power. Fasteners frequently jam the stapler. stapler does not fire. cause 1.
Warranty and returns grizzly industrial, inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. this warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance.
14. do you think your purchase represents good value? 15. Would you recommend grizzly to a friend? 16. Would you allow us to use your name as a refer- ence for grizzly customers in your area? note: We never use names more than three times. 17.Comments:________________________________ _________________________________________...
Page 16
Catalog to a friend: name________________________________ street________________________________ City______________state______zip_______ Fold along dotted line grizzly industrial, inc. p.o. box 2069 bellingham, Wa 98227-2069 tape along edges--please do not staple place stamp here...