Default Settings
Table 5
shows the default settings for the Switch 4400:
Table 5 Default Settings
Feature
Automatic IP Configuration
Port Status
Port Speed
Duplex Mode
Power over Ethernet
Flow Control
Broadcast Storm Control
Virtual LANs (VLANs)
Link Aggregation Control
Protocol (LACP)
IP Multicast Filtering
Rapid Spanning Tree Protocol Enabled
Fast Start
RMON Alarm
Smart Auto-Sensing
Webcache Support
Traffic Prioritization
Port Security
Configuration Save and
Restore
To make Webcache Support, Traffic Prioritization and Configuration Save
and Restore available on the SuperStack 3 Switch 4400 SE, upgrade the
product to the Switch 4400 SE Enhanced Software Upgrade (3C17207).
Switch 4400
Enabled
Enabled
10/100 Mbps ports are auto-negotiated
All fixed 10BASE-T and 100BASE-TX ports are
auto-negotiated
Enabled (3C17205 only)
Enabled in half duplex
■
Auto-negotiated in full duplex
■
Enabled
All ports belong to the untagged Default VLAN
(VLAN 1) with IEEE Std 802.1Q-1998 learning
operational
Disabled per port
Filtering enabled
Enabled on front panel ports
■
Disabled on rear panel port
■
Enabled
Enabled
Disabled
All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to "best effort" for all other traffic.
Disabled per port
Disabled
Default Settings
21