Default Settings - 3Com 3C17708-US - Switch 4050 Getting Started Manual

Default Settings

Table 5 shows the default settings for the Switch 40x0. If you initialize
one of the Switch units, it is returned to these defaults.
Table 5 Default Settings
Feature
Port Status
Port Speed
Duplex Mode
Flow Control
Broadcast Storm Control
Virtual LANs (VLANs)
Multicast Filtering
Rapid Spanning Tree Protocol
Link Aggregation Control
Protocol (LACP)
Spanning Tree Protocol
Smart Auto-sensing
IP Address
Subnet Mask
* This default IP address is used if the unit is operating in standalone mode, and/or no other
Switches on the network have this IP address. If this default IP address is already in use then the
Switch detects this and configures itself with an IP address in the range 169.254.1.0 to
169.254.254.255.
Default Settings
3Com Switch 40x0 Family
Enabled
Auto-negotiated
Auto-negotiated
Auto-negotiated
Enabled
High threshold: 3000 broadcast frames per
second — Notify and filter
Low threshold: 1500 broadcast frames per
second — Notify and unfilter
All ports belong to the untagged Default VLAN
(VLAN 1)
IGMP filtering enabled
Enabled
Disabled per port
Enabled
Enabled
169.254.100.100 *
255.255.0.0
21