Display Assembly - HP 3105m Maintenance And Service Manual

Display assembly

Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation mode,
turn on the computer, and then shut it down using the operating system.
2. Disconnect all of the external devices that are connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the hard drive (see
7. Disconnect the wireless antenna cables from the WLAN module (see
on page
8. Remove the keyboard (see
9. Remove the top cover (see
Remove the display assembly:
1. Position the computer display-side up, with the front toward you.
2. Open the computer as far as possible.
3. Disconnect the display panel cable (1) from the system board.
4. Remove the wireless antenna cables from the clips (2) and routing channel built into the base
enclosure.
CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
5. Remove the 4 screws (1) that secure the display assembly to the base enclosure.
ENWW
Battery on page
Hard drive on page
39) and WWAN module (see
Keyboard on page
Top cover on page
Support the display assembly when removing the following screws. Failure to
32).
Hard drive on page 33).
33).
WWAN module on page
43).
45).
WLAN module
37).
Component replacement procedures 51