Maintenance - Travis Industries 21E Owner's Manual

Other Remote Control Functions
Frequency Interference
If the fireplace does not respond properly to the remote
control, the remote operating frequency may have to be
reset. The remote control can send another frequency code
to the circuit board to eliminate interference.
1. Simultaneously press the O. Sleep Timer Down button
and the Q. Audio Volume Down button on the remote
control.
2. "COD" will appear in place of the sleep timer digits.
3. Release the O. Sleep Timer Down button and the
Q. Audio Volume Down button.
4. Press the Initialization Button on the unit (Figure 12).
5. Press the A. Flame/Heat On/Off
remote.
Your remote will now have a different frequency
communicating with the fireplace.
Child Lock
1. Depress tab on the battery cover on the back of the
remote transmitter and remove the battery cover
(Figure 13).
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire,
electric shock or damage to persons.
You will need to remove the face to access the fireplace.
The face is held in place with short hooks and a screw (or
bolt). With the fireplace cool, remove the screw or bolt and
lift the face upwards and forward to remove. Place the face
on a soft surface to prevent scratches.
Glass Cleaning
The glass is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
glass may collect dust particles; these can be removed by
dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be
cleaned with a damp cloth. To prevent scratching, do not
use abrasive cleaners or spray liquids on the glass surface.
© 2010 Travis Industries Inc.
Operation
button on the

Maintenance

100-01183_000
Figure 15
Unlocked
2. Move Child Lock tab to the right to lock the remote
transmitter (Figure 15).
3. Move Child Lock tab back to the left to unlock the remote
transmitter.
4. Replace the battery cover.
! NOTE: To temporarily unlock the remote transmitter
press (in order): I. Temperature Down; then
J. Temperature Up; then K. Dimmer Down (Figure 14).
When the remote transmitter's backlight is illuminated
the Child Lock is bypassed. When the backlight is off the
Child Lock is re-activated.
Fireplace Surface Cleaning
Use a cloth dampened with warm water only to clean
painted surfaces of the electric fireplace. Do not use
abrasive cleaners.
11
Locked
Child Lock Switch