Basic Setup And Configuration; General Functions; Spoken Status Announcements; Audio Sources And Priorities - Cardo Systems SCALA RIDER G4 POWERSET User Manual

Your wall charger and USB adaptor cable serve
two purposes:
1. Charging your headset from any A/C
wall socket or from a USB port on your
computer (charging time from computer takes longer)
2. Downloading software upgrades from Windows™ XP or Vista™
based computers (see section 4.4 for details).

4. BASIC SETUP AND CONFIGURATION

4.1 GENERAL FUNCTIONS

DESIRED RESULT REQUIRED ACTION
Turn on the headset
Press the Mobile Button steadily for at least four
seconds
Led indication: Three blue flashes.
Audio feedback: Ascending tone (low-high).
Turn off the headset
Press the Mobile Button steadily for at least three
seconds
Led indication: Three red flashes.
Audio feedback: Descending tone (high-low).
Increase the volume
Tap the Volume Up Button
Decrease the volume Tap the Volume Down Button
Mute Tap simultaneously Volume Up and Volume Down
while any audio is on
Battery Level Press and hold the Volume Up Button for three
Indicator
seconds
Blue light = Battery is fully charged
Red/blue light = Battery is half full
Red light = Battery is almost empty

4.2 SPOKEN STATUS ANNOUNCEMENTS

Your scala rider G4 headset offers various audio status messages
sent through your speakers. Among others, it will announce your con-
nection state, e.g. whether you are in mobile phone or on intercom
mode, it will confirm changes of such modes and more. By default
the feature is ON, and can be disabled as outlined below.
The Voice menu can be set at any one of the available language op-
tions. In the future, more languages will be available for downloading
from our website (see section 4.4 for Firmware Upgrade).
Entering the Voice Menu: Press and hold the CHANNEL "A" button
and CHANNEL "B" button simultaneously for 3 seconds while the
headset is on standby. Once entering the system, follow the voice
instructions in English or choose your preferred language.
Disable/Enable status announcements: Press and hold the
Volume Down Button for 6 seconds.
ON: Led indication: Solid blue + Audio feedback: One short beep
OFF: Led indication: Solid red + Audio feedback: Two short beeps

4.3 AUDIO SOURCES AND PRIORITIES

The different audio sources connected to the G4 are prioritized as
shown below, i.e. the higher priority source will always override and
interrupt the lower one.
For example, incoming mobile phone calls will interrupt ongoing
Intercom calls, while incoming intercom calls will interrupt the audio
from the built-in FM Radio etc.
1. Mobile phone audio or GPS instructions
Higher Priority

(device specific)
2. Intercom
3. A2DP audio source
4. FM Radio (built-in)
5. Auxiliary Line-In Port (for corded connection
Lower Priority
e.g. MP3 players).
scala rider G4 PowerSet
® ™
5