Setup And Configuration - Cardo Systems Scala-rider Q2 User Manual

CONTENTS OF RETAIL BOX | BEFORE USING |
Wall Charger
Allen Wrench
Velcro Pads
Extension Pad
Carry-Pouch
Microphone Sponge
User Guide, including Warranty and Registration form
IMPORTANT:
The scala-rider Q2 is a water-resistant device, designed for use under
moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least five hours
before initial use.
1. Connect the wall charger to the headset's Charging Jack
(located between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to
15 seconds until the Red Light turns on). When charging is
complete, the Red Light will turn off.
QGQ2_A5_021.indd 3
SET UP AND CONFIGURATION
Rider-to-
Passenger
Full Duplex
Intercom
Connection
scala-rider Q2 or
scala-rider
Family Headset
STEP 1
SET UP FOR BIKE-TO-BIKE INTERCOM: PAIRING
The scala-rider Q2 can be paired with up to two other headsets for
Intercom communication, referred to in this guide as:
Primary Buddy
and
Secondary Buddy
Pairing is a one time process. Once the headsets are paired during
this Setup Procedure, they will remain paired and automatically
recognize each other whenever they are within range.
NOTE: The scala-rider Q2 allows you to speak via Intercom to one
Buddy headset at a time.
3
scala-rider Q2™ |
Embedded Embedded
FM Radio FM Radio
Bike-to-Bike Bike-to-Bike
Intercom Intercom
500 meters
(1,640 ft.)
Mobile Phone
GPS
2/19/08 1:51:54 PM