Related Manuals for Cardo Systems SCALA RIDER SOLO
Summary of Contents for Cardo Systems SCALA RIDER SOLO
-
Page 1: User Guide
™ Solo ™ communication in motion ™ Gebrauchsanleitung Guide d’Utilisation Guida di Avvio Guia de Usario User Guide... - Page 2 © Cardo Systems, Inc. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Cardo Systems, Inc. is under license. Other trademarks and trade names are those of their respective owners.
- Page 3 Volume Headset Congratulations, and thank you for choosing the scala rider Solo Bluetooth® Headset for bikers. Cover tongue & Charging The scala rider Solo headset offers the following Jack communication options: Volume Down 1. Bluetooth headset for mobile phone communication, supporting Headset* and Handsfree* profiles (10m / CTRL –...
-
Page 4: Setup And Configuration
1. Turn on your phone and make sure its Bluetooth function is activated. before initial use. 2. With the scala rider Solo headset turned OFF, press and hold the 1. Connect the wall charger to the headset’s Charging Jack CTRL Button until the Red and Blue Lights begin rapidly alternating. - Page 5 4. After a few seconds the phone will list the scala-rider 2. With the scala rider Solo headset turned OFF, press and hold as a discovered device. Select it and follow your phone’s the CTRL Button until the Red and Blue Lights begin rapidly instructions to accept the pairing.
-
Page 6: Positioning The Speakers
Standard Method 3. Adjust the Helmet Clamp’s location on the Helmet so that the microphone is located opposite your mouth. You may need to reposition the Clamp 1. Use the enclosed Allen Wrench to loosen the repeatedly until you identify the best spot. The two screws on the Back Plate. -
Page 7: Audio Sources And Priorities
AGC (Automatic Gain Control): In addition to manual Volume Control, the scala rider Solo will automatically increase and reduce its vol- We recommend that you remove the ume according to ambient noise and driving speed. -
Page 8: Status Lights
NOTE: If your Bluetooth mobile phone is paired to a Bluetooth GPS INITIATING AND RECEIVING MOBILE PHONE CALLS device, not directly to the scala rider Solo, some of the above Phone functions may not be compatible. Voice Recognition – VR (VOX) - Page 9 on the MP3 cable holder should be fixed into corresponding SUPPORT indentations on clamp. For additional information please visit our website at 3. Place the Back Plate on top of the MP3 cable holder and secure www.cardosystems.com all parts together using the Allen screws that were previously FAQ: www.cardosystems.com/support/faq removed, as shown in photo.
- Page 10 European CE Notice 15.105(b) The scala rider Solo headset (the “Product”) is in conformity with the fol- lowing essential requirements of Council Directive 1999/5/EC (referred to as This equipment has been tested and found to comply with the limits for a R&TTE Directive): Articles 3.1a, 3.1.b and 3.2.
-
Page 11: Waiver And General Release
2. You fully understand and assume the risks in using the Device, including weather and road conditions if you choose to use the scala rider Solo risk of negligent acts or omissions by others. - Page 12 signing or manufacturing the Device; (c) these risks and dangers may arise from ON BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LI- foreseeable or unforeseeable causes. You hereby assume all risks and dangers ABILITY OR OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAM- and all responsibility for any losses and/or damages, whether caused in whole AGES.