Set Up And Configuration; Set Up Bike-To-Bike Intercom: Pairing; Before Using (Charging The Headset) - Cardo Systems SCALA RIDER Q2 PRO User Manual

Wall Charger
Allen Wrench
Velcro Pads
MP3 Cable
MP3 Cable Holder
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
The scala rider Q2
pro
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset's Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete,
the Red Light will turn off.
scala rider Q2
4 4 ® ™
pro
IMPORTANT:
is a waterproof and dustproof device.

SET UP AND CONFIGURATION

Built-in
FM radio
Mobile phone
& A2DP
connectivity
Driver-to-Passenger
Full-duplex
Intercom
Connection
scala rider Q2 or
pro
other scala rider
headset
SET UP FOR BIKE-TO-BIKE INTERCOM:
PAIRING
The scala rider Q2 can be paired with up to two other headsets
pro
for Intercom communication, referred to in this guide as:
Primary Buddy
and
Secondary Buddy
Pairing is a one time process. Once the headsets are paired during
this Setup Procedure, they will remain paired and automatically
recognize each other whenever they are within range.
NOTE: The scala rider Q2 allows you to speak via Intercom to
pro
one Buddy headset at a time.
GPS
MP3
player
Bike-to-Bike Intercom
up to 700 m / 2,300 ft
(in open terrain)