NOTE: A standard steering wheel puller and two1/4–28
x 3 or 4 in. long screws are required to remove
the clamp.
NOTE: Refer to Fig. 27.
1
Loosen the two screws (4) on the clamp (15), work-
ing through the slot at the bottom of the clutch hous-
ing (17).
2
Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp. Tighten the screw (C)
until the clamp comes off.
3
Go to Reassembly, page 30, Step 3, or continue
below.
NOTE: Refer to Fig 29–2.
1
Remove the capscrews (11) and
lockwashers (12) which hold the
clutch housing (17) to the engine (45).
2
Remove the engine key (14).
3
Pull off the clutch housing (17).
4
Go to Reassembly, page 30, Step 1.
Clamp
A
B
C
Fig. 27
Clutch Housing
17
12
11
Fig. 28
17
15
45
14
4
TORQUE TO
125 in–lb
(14 N.m)
0155
0156