Spray Tip And Tip Guard - Graco Roof Rigs 224483 Instructions-Parts List Manual

Gasoline powered airless sprayer 1200 psi (8.3 mpa, 83 bar) maximum working pressure

Hide thumbs

Table of Contents

WARNING

To reduce the risk of fluid injection or splashing in

the eyes or on the skin, completely relieve the fluid

pressure before installing, cleaning, or changing

tips. See the Pressure Relief Procedure on page

Installation

1. Insert the housing through the back of the retaining

nut and pull it forward. See Fig. 7.

2. Install the metal seal in the housing, flat side first.

See Fig. 8.

3. Install the cylinder tip in the housing so its small ori-

fice faces front. See Fig. 9.

4. Snap on the tip guard. Install the screw and the white

gasket. See Fig. 10.

Operation

Be sure the tip arrow handle is in the FULL SPRAY posi-

tion before operating the gun. See Fig. 10.

WARNING

Keep clear of the nozzle. High pressure fluid from

leaks or spray can penetrate the skin and cause

extremely serious injury, including the need for

amputation. The tip guard provides extra protection

against injection, but does not prevent it. Never cut

off the tip guard.

Clearing a clogged spray tip

1. Engage the trigger safety latch.

2. Turn the arrow handle to the FULL CLEAN position.

3. Disengage the trigger safety latch and trigger the gun

into the waste container.

4. Engage the trigger safety latch. Return the arrow

handle to the FULL SPRAY position.

Maintenance

Replace the gasket and seal whenever you replace a tip;

these parts wear at about the same rate.