Spirit CT800 Owner's Manual page 10

18
20
59
58
104
104
33
73
STEP 1: Console Mast T ubes
The right side console mast tube (19) has computer cable A (87) pre-installed. Lift the tube off the walking
1.
surface and attach it to the base frame. You need to gently pull on the computer cable as you line up the upright
tube, taking the slack out, so the cable does not get pinched between the tube and the base frame. Assemble
one bolt (104), split washer (58) and flat washer (59) through the top hole in the retaining plate (21), and
corresponding top hole in the upright tube, and screw into the base frame. Now install the other two bolts
(104) and washers (58 & 59) and tighten all three securely.
2. Install the left console mast tube (18) in the same manner.
3. Install the lower side caps (32 & 33) with four screws (73).
HARDWARE
#58. 3/8"
Split Washer
(6 pcs)
CT800
T readmill
#59. 3/8"
Flat Washer
(6 pcs)
A
19
#104. 3/8" x 3-3/4"
Stainless Steel Bolt
(6 pcs)
6
104
58
59
104
58
59
21
#73. M5 x 12mm Self
Tapping Screw
(4 pcs)
73
32