Electrical Safety; Electrical Supply; Power Cord - Xerox WorkCentre 5325 User Giude

Workcentre 5300 series
Hide thumbs Also See for WorkCentre 5325:
Table of Contents

Advertisement

Safety

Electrical Safety

WARNINGS:
Do not push objects, including paper clips or staples, into slots or openings on the printer.
Making contact with a voltage point or shorting out a part could result in fire or electrical shock.
Do not remove the covers or guards that are fastened with screws unless you are installing
optional equipment and are specifically instructed to do so. Power should be OFF when
performing these installations. Disconnect the power cord when removing covers and guards
for installing optional equipment. Except for user-installable options, there are no parts that
you can maintain or service behind these covers.
The printer must be turned off before removing the power cord. For instructions on turning the printer
off, see
Turning the Printer On
The following are hazards to your safety:
The power cord is damaged or frayed.
Liquid is spilled into the printer.
The printer is exposed to water.
If any of these conditions occur, do the following:
1.
Turn off the printer immediately.
2.
Disconnect the power cord from the electrical outlet.
3.
Call an authorized Xerox representative.

Electrical Supply

The printer must be operated from the type of electrical supply indicated on the printer's data plate
label. If you are not sure if your electrical supply meets the requirements, please consult a licensed
electrician for advice.
WARNING:
This printer must be connected to a protective earth circuit. This printer is supplied
with a plug that has a protective earth pin. This plug will only fit into an earthed electrical outlet.
This is a safety feature. If you are unable to insert the plug into the outlet, contact a licensed
electrician to replace the outlet.

Power Cord

Always connect equipment to a correctly grounded power outlet. If in doubt, have the outlet
checked by a qualified electrician.
Use the power cord supplied with your printer.
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
Do not use an extension cord or power strip.
12
WorkCentre 5300 Series Multifunction Printer
User Guide
on page 38.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workcentre 5335Workcentre 5330

Table of Contents