Tip Selection; Selecting Tip Hole Size - Graco MAGNUM 309225W Operation Manual

Tip Selection

Selecting Tip Hole Size

Tips come in a variety of hole sizes for spray-
ing a range of fluids. Your sprayer includes an
0.015 in (0.38 mm) tip for use in most spraying
applications. Use the following table to deter-
mine the range of recommended tip hole sizes
for each fluid type. If you need a tip other than
the one supplied, see the Reversible Tip
Selection Chart on page 14.
Tip Hole
Size
Stains
(expressed as
diameter,
based on area
of elliptical
orifice)
✔
0.011 in.
(0.28 mm)
✔
0.013 in.
(0.33. mm)
0.015 in.
(0.38 mm)
0.017 in.
(0.43 mm)
0.019 in.
(0.48 mm)
309225W
Coatings
Enamels Oil-base
primers
and paints
✔ ✔
✔ ✔
✔
HINTS
:
• As you spray, the tip wears and enlarges.
Starting with a tip hole size smaller than the
maximum will allow you to spray within the
rated flow capacity of the sprayer.
• Maximum tip hole sizes supported by the
sprayer:
– dx: 0.015 in. (0.38 mm)
– XR5: 0.015 in. (0.38 mm)
– XR7: 0.017 in. (0.43 mm)
– XR9: 0.019 in. (0.48 mm)
Interior Exterior
latex
paints
✔
✔
✔
Tip Selection
Acrylics
latex
paints
✔
✔ ✔
✔ ✔
13