Graco MAGNUM 309225W Operation Manual page 18

Shutdown and Cleaning
9. Turn lever to close power
flush attachment.
10. Unscrew inlet screen from
suction tube. Place inlet
screen in waste pail.
11. Connect garden hose to suction
tube with Power Flush attach-
ment. Leave prime tube in waste
pail.
12. Turn Spray-Prime/Drain valve
to SPRAY.
13. Align arrow on
sprayer with pail
symbol on Pressure
Control knob until
pump starts.
14. Open lever on Power
Flush attachment.
18
Step 15 is for returning paint in hose back
to paint pail. One 50-ft (15-m) hose holds
approximately 1-quart (1-liter) of paint.
15.
a. Pull and hold gun trigger. Point gun into
paint pail.
b. Turn power switch ON to begin pumping
paint in hose back into paint pail.
c. When water comes out of gun, continue
to trigger gun, aiming gun into waste
pail.
16. Continue triggering gun into waste pail for
1-2 minutes, until relatively clear water
comes out of gun.
17. Turn Spray-Prime/Drain valve
to PRIME.
18. Circulate water through
sprayer, into waste pail, for 20 seconds.
19. Turn power switch OFF.
20. Close Power Flush
attachment. Turn off
garden hose.
21. Unscrew Power Flush attach-
ment from suction tube.
309225W