Setting Your Changes As A New Default; Restoring All Settings To The Factory Settings - Brother DCP-J125 User Manual

Chapter 7
Using a scanned paper document as
your watermark
a
Press (COPY).
b
Enter the number of copies you want.
c
Press a or b to choose
Watermark Copy.
Press OK.
d
Press d or c to choose On.
e
Press a or b to choose
Current Setting.
Press OK.
f
Press a or b to choose Scan. Press OK,
and place the page that you want to use
as a watermark on the scanner glass.
g
Press Mono Start or Colour Start.
h
Take out the watermark document you
scanned and load the document you
want to copy.
i
Press d or c to change the
Transparency of the watermark.
Press OK.
j
If you do not want to change any
additional settings, press Mono Start or
Colour Start.
Note
You cannot enlarge or reduce the
scanned watermark.
34
Setting your changes as a
new default
7
You can save the copy settings for Quality,
Enlarge/Reduce, Density,
Ink Save Mode and Page Layout that
you use most often by setting them as the
default settings. These settings will stay until
you change them again.
a
Press
b
Press a or b and d or c to choose your
new setting.
Press OK.
Repeat this step for each setting you
want to change.
c
After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d
Press 1 to choose Yes.
e
Press Stop/Exit.
Restoring all settings to the
factory settings
You can restore the copy settings
Quality, Enlarge/Reduce, Density,
Ink Save Mode, and Page Layout, that
you have changed, to the factory settings.
a
Press
b
Press a or b to choose
Factory Reset.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
(COPY).
(COPY).
7
7