Manual Start Up - Harman Stove Company PC 45 Installation & Operating Manual

Fig. 24
Corn burnpot Setup
Fig. 25
Pellet burnpot Setup
Fig. 26
warning
"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL,
KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMILAR
LIQUIDS TO START OR "FRESHEN UP " A FIRE IN THIS
HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE
HEATER WHILE IN USE".
18 PC 45 Corn/Pellet Stove

mANuAl STArT uP

Igniter Switch to"mANuAl"
Make sure the unit is plugged into a 120 VAC, 60 HZ
electrical source. The power light should be the only light
lit. Anytime there is interruption in power at the receptacle,
the combustion blower will run for 1 minute after the power
is regained.
burning Corn
1. Turn the Feed Adjuster to the desired feed rate,
approximately #2.
2. Turn the Mode Selector to "OFF" and then to the desired
mode. This will reset the control and start the combustion
motor.
3. Turn the Temperature Dial to the desired setting.
4. Clean the burnpot and housing, if necessary.
5. Fill the burnpot with corn up to the auger shaft. Then place
pellets on top of the corn as high as the shelf area. See corn
burnpot shown on left.
6. Add starting gel on top of the pellets, stir gel into the pellets
and corn for faster lighting.
7. Light the starting gel with a match and close the door.
Operation will begin when the fire reaches the proper
temperature.
8. Fill the hopper with corn and remove the ashes as
required.
burning Pellets
1. Turn the Feed Adjuster to the desired feed rate,
approximately #4.
2. Turn the Mode Selector to "OFF" and then to the desired
mode. This will reset the control and start the combustion
motor.
3. Turn the Temperature Dial to the desired setting.
4. Clean the burnpot and housing, if necessary.
5. Fill the burnpot with pellets so that the auger tube opening
is covered and slopes away from the auger tube opening. See
pellet burnpot shown on left. If using corn burnpot setup, fill
to same level as corn above.
6. Add the starting gel on top of the pellets. Stir the gel into
the pellets for fast lighting.
7. Light the starting gel with a match and close the door.
Operation will begin when the fire reaches the proper
temperature.
8. Fill the hopper with pellets and remove the ashes as
required.
To kill the fire or stop burning the stove, turn the Mode
Selector to "OFF". This will cause the fire to diminish and
burn out. When the fire burns out and the stove cools down
everything will stop. NOTE: The combustion blower
motor will be the last component to stop. This insures
that all fuel in the burnpot and ashes located in the ash pan
are completely cold before shut down of the combustion
motor.
If you pull the plug to shut down the stove, all motors will
stop. This may cause incomplete combustion and smoke in the
firebox. If the load door is opened the smoke may escape.
The best way to shut down the stove is simply let it run out
of fuel, then the stove will shut down automatically.
Starting the Fire
Shut-down Procedure
(down position)