Automatic Start Up - Harman Stove Company PC 45 Installation & Operating Manual

Fig. 21
16 PC 45 Corn/Pellet Stove

AuTOmATIC STArT uP

Starting the Fire
Igniter Switch to"AuTO"(up position)
Make sure the unit is plugged into a 120 VAC, 60 HZ
electrical source. The power light should be the only
light lit. Anytime there is an interruption in power at the
receptacle, the combustion blower will run for 1 minute
after the power is restored. The control uses this time
to determine exhaust temperature and if there is a need
to remain on.
bE SurE ThErE IS NO FuEl Or OThEr
COmbuSTIblES IN ThE ASh PAN PrIOr TO
lIghTINg.
1.Turn the Mode Selector to "OFF"
2. Fill the hopper with corn or pellets.
3. Clean the burn pot and housing, if necessary.
4. If starting after an empty hopper, turn the feed
adjuster to "TEST" until the fuel is visible in the auger
tube opening. This also allows you to check the motors
for operation.
NOTE: The auger motor will not operate with the view
door or ash door open.
NOTE: The initial start-up on a new stove may require
the corn to be purged into the burnpot area before
continuing to step 5.
5. Turn the feed adjuster to #2 (corn) or #4 (pellet)
6. Flip the igniter switch up into the "AUTO" position.
7. Turn the temperature dial to the desired setting.
8. Turn the mode selector dial to Room Temperature or
Stove Temperature.
9. Fill the hopper with corn or pellets and remove the
ashes as required.
warning
"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP " A
FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS
WELL AWAY FROM THE HEATER WHILE IN USE".