Harman Stove Company PC 45 Installation & Operating Manual page 14

For optimal performance burning wood pellets, the pellet kit #1-00-06801 is now
included. This kit allows you to convert the PC45 into a fully automatic pellet
stove with 50,000 BTU capacity, fast ignition and clean viewing glass. Due to the
fact that there are changes needed for the circuit board programing, it is recom-
mended that this installation be completed by a trained service technician. Be
sure the power cord is un-plugged prior to adjusting circuit board switches. The
pellet kit contains the instructions for the conversion, a new burn pot end gate,
and a new combustion blower inlet ring.
This figure shows the corn burn pot
as installed from the factory.
The combustion blower inlet ring on the left is the one originally installed in the stove. Note the
larger opening in the ring on the right. This allows the PC45 to produce more heat when burning
pellets. The larger ring does the opposite when burning corn. If you want to switch back to corn or
grain, exchange the inlet ring back to the smaller opening.
14 PC 45 Corn/Pellet Stove
Pellet Fuel Optimization
This figure shows the new end
gate which gets installed without
the stirring rod.
This figure shows the pellet burn
pot after installing the new end
gate.