Connector Descriptions And Pin Definitions - Supero AOC-SIMSO User Manual

2.2.3 Connector Descriptions and Pin Definitions

#5 (J1) Mini Universal Serial Bus (USB)
Connector
There is a mini USB connector (J1) located on the
AOC-SIMSO/SIMSO+ and another mini USB con-
nector is located on the AOC-USB2RJ45. Use Cable
CBL-0165L or CBL-0177L (*) to connect the two mini
USB connectors on both add-on cards for external
LAN access. Refer to Page 2-1 for details. See the
table at right for the pin definitions.
Refer to Note 2 on Page 2-1.
The SKT-0240L
Mini USB
Connector
#6 (JBT1) RISC CPU Reset
JBT1 is used to reset the Kira 100 Processor, NIC,
UART, USB and R.T. Instead of pins, this "jumper"
consists of contact pads to prevent the accidental
reset. Use a metal object such as a small screwdriver
to touch both pads at the same time to short the
connection. After a reset or AC power-on, the AOC-
SIMSO(+) will automatically detect if a CBL-0165L
cable is connected. If a cable is not detected, the
AOC-SIMSO(+) will transfer the "Remote Control"
Function to LAN1 on the motherboard. If a cable is
detected, the AOC-SIMSO(+) will use the dedicated
LAN on the card to manage motherboard activities
via Remote Console.
(Note: The SKT-0240L is included in the SIMSO+
shipping package.)
Chapter 2: Technical Specifications and Installation
(Note Below)
AOC-SIMSO(+)
CBL-0165L Cable or
CBL-0177L Cable* (See
Note 2 on Page 2-1)
AOC-USB2RJ45
2-3
Mini USB Pin Definitions
(J1)
Pin# Definition
1 Eth-TX_H
2 Eth-TX_L
3 Phy-100
4 Eth-RX_L
5 Eth-RX_H
6 Phy-ACT
7 Det.icated LAN-
Detected
8 3V-duall
9 Ground