Supero AOC-SIMSO User Manual page 40

AOC-SIMSO/SIMSO+ User's Guide
3. Network Basic Settings: This window allows you to configure basic settings for
your network.
4. IP Auto Configuration: Click on the box to activate the selection menu and select
a desired item from the list. The options are None, DHCP, and BOODP.
5. Preferred Host Name (DHCP only): Enter a Preferred Host Name in the box.
6. IP Address: Enter the IP Address for the remote host in the box.
7. Subnet Mask: Enter the net mask of the local network in the box.
8. Gateway IP Address: Enter the local network router's IP address in this box for
the accessibility of the users that are not connected to the local network.
9. Primary DNS Server IP Address: Enter the IP Address of the Primary Domain
Name Server in the box.
10. Secondary DNS Server IP Address: Enter the IP Address of the Secondary
Domain Name Server in the box. It will be used when the Primary DNS Server can-
not be contacted.
11. Network Miscellaneous Setting: This field allows the user to configure the fol-
lowing Network Miscellaneous settings as listed below:
12. Remote Console & HTTPS Port: Enter the port numbers the remote host and
the HTTP server are listening. If a number is not entered in the box, the default value
will be used.
13. HTTP Port: Enter the port number the HTTP server is listening. If a number is not
entered in the box, the default value will be used.
14. SSH Port: Enter the port number the SSH server is listening. If a number is not
entered in the box, the default value will be used.
15. Bandwidth Limit: Enter the maximum bandwidth value for network interfacing.
The value should be in Kbits per second.
16. Enable SSH Access: Click this box to enable SSH Access.
17. Disable Setup Protocol: Check this box to disable the function of Setup Proto-
col for the SIMLP card.
18. LAN Interface Setting: This field allows the user to configure the following LAN
Interface settings as listed below:
19. LAN Interface Speed: Click on the arrow on the right to activate the selec-
tion menu and select a desired speed. The options are: Auto-detect, 10 Mega bits
per second or 100 Mega bits per second. If Auto-detect is selected, LAN Interface
Speed will be set at the optimized speed based on the system configurations de-
tected by the OS.
19. LAN Interface Duplex Mode: Click on the arrow on the right to activate the se-
lection menu to select a desired LAN Interface Duplex Mode. The options are: Auto-
detect, Half Duplex and Full Duplex. If Auto-detect is selected, the LAN Interface
Duplex Mode will be set to the optimized setting based on the system configurations
detected by the OS.
3-26