Supero AOC-SIMSO User Manual page 64

AOC-SIMSO/SIMSO+ User's Guide
i./ii. Local Drive List: The box displays a list of local drives available for remote ac-
cess. Select from the list a local drive that you want to make accessible for a remote
server.
iii. Refresh: Click this button to refresh the local drive list.
iv. Write Support: Check this button to allow the remote operating system to have
write access to the drive that you have selected. This function allows a user to alter,
overwrite, erase and destroy data stored in the drive selected. This feature should
only be used with non-critical data. When "Write Support" is checked, the warning
message as shown below will display. Read the warning message carefully before
enabling this function.
Warning Message
v. Connect: Click this button to make the drive you have selected accessible for re-
mote console interaction. Once you have clicked "connect," users logged in remote
servers will have access to the local drive that you have selected.
vi. Disconnect: Click this button to cancel the connection established between a lo-
cal drive and a remote server. Once you click this button, the drive you have selected
will not be accessible for remote console interface.
vii. Sending Commands: This functions allows the user to issue a pre-defined com-
mand to a remote server for execution.
To use this function, you need to click the hot keys displayed on the upper right
corner of the screen as shown below. (Note: Hot keys are the commands that have
been pre-defined and pre-stored in a remote consoles.)
Click Button 7 "Ctrl+Alt+Delete" as shown on Page 3-49 to send the command
"Ctrl+Alt+Delete" to the remote server for execution.
Once you have clicked on the button, a message displays, asking you if you really
want to send "Ctrl+Alt+Delete" as shown in the picture on the next page. Click "Yes"
to confirm it or click "Cancel" to stop sending the command for remote execution.
3-50